Published 2026-11-18 · Updated 2026-11-18

Short answer: iTankData is a battery-powered remote tank monitor with a web portal and phone app, built by a Texas company for oilfield tanks. If all you need is how full the tank is and an alarm before it runs over, it does that job. If you also need casing or flowline pressure and whether the compressor is running, you need a whole-site monitor. TinyPumper watches tanks, pressures and runtime on one gateway, for one flat rate per site, and your team installs it in 8 minutes.

Picture a saltwater tank that reads fine all weekend while the compressor down the road quit Friday night. The tank monitor did its job. Nobody was watching the rest of the lease. That gap is what this page is about.

Is iTankData or TinyPumper the Better Fit for My Lease?

It depends on what you need to see. If a lone tank level and a high-level alarm is the whole job, iTankData’s tank monitor can be the simpler buy. If you also need casing or flowline pressure and compressor runtime, TinyPumper watches all three on one gateway, at $349 a sensor, one-time setup, plus one flat monthly rate per site, as of November 2026. If you need to open valves or shut wells in from the office, neither one replaces SCADA.

What Is iTankData?

iTankData is a remote tank and tote level monitor sold by iTankData, a Texas company that pitches its mobile app as built “by oil field people, for oil field people.” The standard unit drops a stainless pressure sensor on a tether into the tank and reports levels over Verizon or AT&T LTE. A separate satellite model runs on the Iridium network with a solar-charged battery.

A few naming notes, because Google mixes them up:

  • itankdata (one word, lowercase) is the same company and the same product.
  • The iTank portal most producers mean is iTankData’s web portal, where tank levels, alarms and the morning tank report live.
  • Some pumpers call the device the iTank oil reader. It is the same tank monitor described above.
  • If you typed itank dats\a, that is a typo for iTankData, and this page covers the same product.
  • WESROC iTank is a propane tank monitor and Browan iTank is a smart tank sensor from a different company. Neither is iTankData.

What Does iTankData Do Well?

We are not going to knock a product for doing what it says. iTankData has real strengths for oilfield tanks:

  • No wiring for a basic install. The company markets a quick install with no electrical connections or extra fittings.
  • Long battery life. iTankData says its power management stretches average battery life to 5 years (iTankData devices page, July 2026).
  • A morning report. Its oil and gas page pitches an 8:00 a.m. tank report and alerts by text and email (iTankData website, July 2026).
  • A path into SCADA. iTankData offers a 4 to 20 mA version, and one customer case study describes hardwiring it into a SCADA system to trigger valves.
  • Remote tanks. The satellite model reaches orphan tank batteries far from cell service.

Where Does iTankData Stop on a Real Lease?

A tank monitor answers one question: how full is the tank? On most leases the costly surprises come from somewhere else.

  • Pressure. Casing, tubing and flowline pressure show a well loading up or a line plugging before the tank ever does.
  • Runtime. A compressor or pumping unit that stopped at midnight costs you every hour until somebody notices.
  • The sensor in the fluid. iTankData’s standard unit hangs a pressure sensor in the tank. Anything that sits in produced water has to live with corrosion, paraffin and freezing.
  • The pumper’s record. A tank number does not tell you whether the pumper came out, so you still cannot prove the visit. It does not catch wells that slip a little each week either. And if the pumper still keys it in at home on the laptop, the office never gets yesterday’s gauges without calling him.

None of those live in a tank-only monitor. So the real question is not “which tank gauge?” It is “what else on this lease do I need to see?”

How Does TinyPumper Compare With iTankData?

  iTankData TinyPumper
What it watches Tank and tote levels, temperature and alarms Tank levels, pressures (wellhead, flowline, injection) and engine or compressor runtime
How the tank is measured Pressure sensor on a tether, in the fluid (iTankData case study) Radar on top of the tank, no fluid contact
Power Battery unit; solar on the satellite model Solar powered gateway, wireless sensors
Install No wiring for a basic install, per iTankData Your team self-installs in 8 minutes
Coverage Verizon or AT&T LTE; Iridium on a separate satellite model 100% continental US coverage because we use satellite
Pricing $625 a unit plus $20 a month for the data plan (reported by The Crude Life, April 2023) $349 a sensor, one-time setup, then one flat rate a month per site, unlimited sensors
Production records Tank reports and data export; run tickets not described on its site Every well with a TinyPumper sensor gets free Greasebook
If it breaks Ask the vendor Lifetime hardware replacement
Trial Ask the vendor 60-day money-back, we pay return shipping

Where a cell says “ask the vendor” or “not described,” iTankData’s public site does not say. Ask them directly before you buy.

Table comparing TinyPumper and iTankData for one remote oil lease: what each watches, tank sensor, coverage, price and production records.

When Is TinyPumper the Better Fit Than iTankData?

  • You need more than the tank: pressures and runtime on the same lease.
  • You want alarms the moment something crosses a line. TinyPumper sensors report every hour and check thresholds every 5 minutes, so an alert goes out right away.
  • You want one price per site, not per tank. iTankData charges its data plan per unit, so a battery with an oil tank, a water tank and a gun barrel adds up. TinyPumper is one flat rate per site with unlimited sensors.
  • You want the daily pumper record too. Every well with a TinyPumper sensor gets free Greasebook, so gauges, run tickets and comments land in the same place as the sensor readings.

Producers running TinyPumper report cutting lease runs by 30 to 50 percent and catching failures days sooner. For the full field of options, see our guide to oilfield monitoring alternatives.

Need the tank, the pressure and the compressor on one screen?

TinyPumper watches all three on one gateway. $349 a sensor, one-time setup, then one flat rate a month per site. 60-day money-back.

See TinyPumper

When Is iTankData the Better Fit?

If one tank level really is the whole job, a focused tank monitor can be the simpler buy. A lone saltwater tank at a disposal site with nothing else to watch is the classic case. And if you already run SCADA and only need a 4 to 20 mA level signal wired into it, iTankData has done that before. If you need full control of instrumented facilities, neither product is the answer.

The Amateur vs. the Pro: Replacing iTankData

The amateur… The pro…
Picks a tank monitor by the price of one unit Prices the whole lease: every tank, the pressure points and the compressor
Accepts a sensor hanging in produced water Asks what happens when it corrodes, fouls or freezes, and who pays to swap it
Lets the tank number replace the pumper’s visit Pairs sensor readings with a pumper record, so the team can prove the visit
Wires a 4 to 20 mA signal into SCADA for one alarm Keeps it wireless unless the site truly needs control

The best operators treat a tank monitor as one piece of the lease, not the whole picture.

What to Avoid When Switching From iTankData

  • Don’t compare unit price to unit price. iTankData’s reported $20 a month data plan is per unit (The Crude Life, April 2023). Count how many units your busiest battery needs before you compare.
  • Don’t skip the pressure question. If casing pressure is creeping on a well, a tank level will not show it until it is too late.
  • Don’t buy without a trial. TinyPumper ships with a 60-day money-back guarantee and we pay the return shipping. Ask every vendor for the same.
  • Don’t confuse the names. WESROC iTank and Browan iTank are different companies. Get quotes from the vendor you actually mean.

TinyPumper Facts as of November 2026

TinyPumper has 100% continental US coverage because we use satellite. Each gateway takes up to 8 sensors. Every order comes with a 60-day money-back guarantee. There is lifetime replacement on all equipment, every sensor included. TinyPumper is GreaseBook’s sister product, and every well with a TinyPumper sensor gets free Greasebook.

Who This Page Is Not For: One-Tank iTankData Buyers

This page is not for producers who only ever need one tank level and an alarm, and it is not for producers who need full SCADA control. If you are weighing other tank-only gauges, see our Tank Sentinel alternative and TankScan alternative pages, or start from the full list of oilfield monitoring options.

About the author: Greg Archbald is the founder of Greasebook and TinyPumper. He built both products from inside the oil patch and has spent 15+ years on the operator side of oil and gas technology.

Frequently Asked Questions

What is iTankData?

iTankData is a Texas company that sells battery-powered remote tank monitors, plus a web portal and phone app, for oilfield tanks. Its standard monitor drops a pressure sensor into the tank and reports levels over Verizon or AT&T LTE, and a solar model reaches remote sites over the Iridium satellite network. Producers also search it as itankdata or the iTank oil reader.

Is the iTank portal the same as WESROC iTank or Browan iTank?

No. The iTank portal most oilfield producers mean is iTankData’s web portal, where tank levels, alarms and the morning tank report live. WESROC’s iTank is a propane tank monitor, and Browan’s iTank is a smart tank sensor from a different company. Check the vendor name before you compare prices, specs or support.

What is the best iTankData alternative?

If one tank level and an alarm is the whole job, another tank gauge will do. If you also need casing, tubing or flowline pressure and compressor runtime, a whole-site monitor fits better. TinyPumper watches tanks, pressures and runtime on one gateway for one flat rate per site, and your team self-installs it in 8 minutes with no electrician.

Does TinyPumper’s tank sensor sit in the fluid?

No. TinyPumper uses a radar sensor that mounts on top of the tank and reads the level without touching the oil or water. There is nothing hanging in the tank to corrode, freeze or gunk up. If a device ever fails, lifetime hardware replacement covers it, and every order comes with a 60-day money-back trial with return shipping paid.

How is TinyPumper priced next to iTankData?

TinyPumper is $349 a sensor, one-time setup. Then one flat rate a month per site, unlimited sensors, so adding a water tank or a pressure sensor on that site adds no monthly charge. The Crude Life reported in April 2023 that iTankData charged $625 a unit plus $20 a month for the data plan on each unit.